Thread Size M5
Thread Pitch 0.8 mm
Length 12 mm
Threading Fully Threaded
Head Diameter 10 mm
Head Height 2.8 mm
Countersink Angle 90°
Drive Style Hex
Drive Size 3 mm
Material Black-Oxide Alloy Steel
Sinclair Bump Gage Inserts are used to measure the amount of shoulder bump when setting up full length sizing dies. Our Bump Gages install in either of our comparator bodies and are machined to fit pa..
This product is easy to use
Finest grade for final finishing of projects
Buffs shellac, lacquer and varnish
Cleans precision tools, instruments etc.
Pack of 12 steel wool pads
For your final finish
This Sinclair Comparator is an excellent tool to use to sort bullets by base to give length. This is a valuable step if you are considering trimming the bullet meplat. NOTE: When sorting a lot of bull..
Our Neck Turning Lube works great with stainless steel and carbide mandrels alike. Acting as both a lubricant and coolant, this oil keeps your turning mandrel slick and doesn\'t drip all over like oth..
The Whidden Gunworks shoulder bump gauge enables you to adjust your sizing die to the desired measurement. The bump gauge is attached to your calipers with a set screw and determines the measurement f..